Round Fireplace Assembly and Instruction Sheet

ManualsBrandsColeman ManualsOutdoor Fireplace5059-704

Assembly and Instruction Sheet

for 30” Round Fireplace

Model 5059-704

Follow these instructions for assembly and read carefully, particularly the

safety statements. The safety alert symbol, is a universally recognized

symbol used to identify safety information about hazards that can result in

personal injury. When this symbol is used you should pay very close

attention to what is written. Review these instructions before beginning

assembly or using your fireplace.

• Check package for all parts needed for assembly.

• Check all items for shipping damage. Call Coleman at 1-800-835-3278 or

TDD: 316-832-8707 if you have any problems.

FOLLOW INSTRUCTIONS AND WARNINGS TO AVOID FIRE,

SERIOUS INJURY OR DEATH.

• Outdoor use only. Never use in enclosed area. Use in unventilated areas

will endanger your life.

• Keep away from all combustible materials including gasoline and other

flammable liquids and vapors.

• Use on a level, noncombustible surface only. Keep away from house,

garage, balconies, or eave overhangs.

• Keep out of the reach of children.

• Be sure screen is in place while in use and do not use in windy conditions.

• Do not overfill firebowl or use to burn leaves and trash.

• Exercise the same care you would with an open fire.

• Never leave unit unattended when hot or in use.

• Completely extinguish fire before leaving.

• Use gloves when handling or moving. Ashes can remain warm for a long

time after extinguishing.

• Dispose of cold ashes properly.

• Do not modify in any way nor use with parts not expressly approved by

Coleman.

• Combustion by-products produced when using this product contain

chemicals known to the State of California to cause cancer, birth defects,

or other reproductive harm.

Contact local authorities regarding possible burn restrictions before using product.

WARNING

Assembly

1. Carefully unpack all parts from shipping box.

2. Assemble Leg Brackets to Leg Support Ring as shown. Attach with

screws. Hand tighten.

Fireplace Parts Check List Assembly (cont.)

3. Place Firebowl Support Ring on top of Leg Brackets as shown. Attach

with screws. Hand tighten.

4. Tighten all screws in Leg Support Ring and Firebowl Support Ring.

Align holes

Firebowl Support Ring

Leg Bracket

Leg Support

Ring

Leg

Bracket

(continued on other side)

■■ 1. Protective Cover

■■ 2. Firebowl

■■

Leg Support Ring

■■

4. Firebowl Support Ring

■■ 5. Leg Brackets

■■ 6. Screen Lifting Tool

■■ 7.

Screen Assembly

■■ 8. Hardware Kit w/Handle

■■ 9. Grate

Summary of content (2 pages)

PAGE 1
® Assembly and Instruction Sheet for 30” Round Fireplace Model 5059-704 Follow these instructions for assembly and read carefully, particularly the safety statements. The safety alert symbol, is a universally recognized symbol used to identify safety information about hazards that can result in personal injury. When this symbol is used you should pay very close attention to what is written. Review these instructions before beginning assembly or using your fireplace. ■ ■ ■ ■ ■ 1. 2. 3. 4. 5.
PAGE 2
Assembly (cont.) 5. Place Firebowl into Firebowl Support. Note: An inch or two of sand should be used in firebowl beneath the grate. After Use WARNING To avoid burns – use heavy gloves to remove screen assembly and grate. 1. Completely extinguish fire before leaving. 2. Do not use water to douse the fire as this may warp the firebowl. 3. Dispose of cold ashes properly. 4. Be careful – fire may be out but firebowl can still be hot. Handle carefully. 5. Store in covered enclosure. Repair Parts List 6.