User Manual

S-S-005596
Air Valve Check
Always check the air valve carefully before inflation to ensure there is not an air leak.
If the air valve is loose, use the provided wrench to fasten the air valve following these
steps:
With one hand, hold the backside of the air valve from the inner side of the spa wall
and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is in use.
6
1. Indoor Installation:
Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with SaluSpa installation. Determine the effects of moisture on exposed wood, paper, etc. in
the proposed location. To minimize these effects, it is best to provide plenty of ventilation to the selected area. An architect
can help determine if more ventilation is needed.
2. Outdoor Installation:
• During filling, draining or when in use, water may spill out of the spa. Therefore the SaluSpa should be installed near a floor
drain.
• Do not leave the spa's surface exposed to direct sunlight for long periods of time.
s
e
c
.
-
l
o
i
n
5
GFCI Test
IMPORTANT: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED
BEFORE TURNING ON THE PUMP EACH TIME.
INSTALLATION
Selected Location
IMPORTANT: Because of the combined weight of the SaluSpa, water, and users, it is
extremely important that the base where the SaluSpa is installed is smooth, flat, level and
capable of uniformly supporting the weight for the entire time the SaluSpa is installed (not
on the carpet or other similar material). If the SaluSpa is placed on a surface, which does
not meet these requirements, any damage caused by improper support is not covered
under the manufacturer’s warranty. It is the responsibility of the SaluSpa owner to assure
the integrity of the site at all times.
WARNING: The GFCI plug must be tested before each use to avoid risk of electric
shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of
the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails and contact our Aftersales Service.
NOTE: When inflating, you will notice that air will be expelled from the area where the
air hose connects to the pump, this is normal
for technique requirements.
NOTE: Do not use an air compressor to
inflate the pool.
NOTE: Do not drag the pool on rough ground
as this may cause damage to the pool liner.
NOTE: Inflation time for reference only.
1. Plug the GFCI into a power outlet, the
indicator turns red.
2. Press the test button, the indicator turns off.
3. Press the reset button, the indicator turns red
and the spa is ready for use.