Installation Guide

Congratulations on your Coleman® solar product purchase. This product is designed to the highest technical
specifications and standards. It will supply years of maintenance free use. Please read these instructions
thoroughly prior to installation, then store in a safe place for future reference. If at any time you are unclear
about this product, or require further assistance please do not hesitate to contact our trained professionals
operating the customer support line 1-888-478-6435 or email to info@sunforceproducts.com
2 Watt Solar 12 Volt Battery Maintainer
Specifications and Included Items:
Power Rating: Up to 2 Watts - Maximum rating – Under optimum conditions.
Current: 133 mAmps @ 15Volts.
Includes:
Solar panel
Alligator Battery Clamps
12 Volt DC plug
Warning
Avoid Electrical Hazards when installing, wiring, operating, and maintaining your Solar Module. The solar
module included generates DC electricity when exposed to sunlight or other light sources.
• For use in 12 Volt systems only.
Observe proper polarity throughout entire power cable wiring route.
Work Safely. Do not wear jewelry when working with electrical or mechanical equipment. Use protective
eyewear when working with batteries or drills. Use extreme caution when on ladders or on a roof.
Follow all Safety Precautions of the battery manufacturer. Some batteries can release flammable hydrogen
gas. Do not produce sparks when working in locations where flammable gases or vapors exist. Shield skin
and eyes from battery acid. Wash thoroughly with water if skin or clothing come in contact with acid or any
corrosive matter, which may have accumulated on the battery. Keep the terminals and casing clean.
Use a Charge Controller for wattages above 15 Watts.
Do not attempt to charge non-rechargeable batteries.
Always connect charge controller to battery first.
When disconnecting, always disconnect battery last.
Features
Quick connect and disconnect to the battery.
Overcharge and discharge protected.
No direct sunlight needed, will work in cloudy conditions.
Five year warranty.
Extension cable included.
Maintenance free and lightweight compact design.
Operating Instructions
For optimal power, ensure the panel (solar cell up) is directly facing the sunlight.
Installation
The 2 Watt Solar Battery Maintainer may be installed using either the included 12 Volt DC plug or the
alligator battery clamps.
Installation through 12Volt DC Plug:
The 12 Volt DC plug is for connecting the Solar Battery Maintainer to the vehicle battery through a 12 Volt
socket. Plug the “Quick Connect” end of the 12 Volt DC plug into the Quick Connect of the solar panel then
insert the plug into the 12 Volt DC socket in vehicle. Make sure both ends are secure and aligned correctly.
Installation to Battery by Alligator Battery Clamps:
The alligator battery clamps are for a direct connection to the vehicle battery terminals. Plug the “Quick
Connect” end of the alligator battery clamps into the Quick Connect of the solar panel then connect the