MODEL #2300-700 Instructions for Use Outdoor use only IMPORTANT Read this manual carefully before assembling, using or servicing this product. Keep this manual for future reference. If you have questions about assembly, operation, servicing or repair, please call Coleman at 1-800-835-3278 or TDD: 316-832-8707. In Canada call 1-800-387-6161. U.S.
General Safety Information cont. Contents General Safety Information System Overview Before You Go To Set Up Use and Operation Helpful Hints Storage 2-3 3 4 4-6 6-7 8 8 Maintenance Troubleshooting Guide Service Replacement Parts Warranty Information Accessories 8 9 9 10 11 12 General Safety Information This manual contains important information about the assembly, operation and maintenance of this water heater.
Before You Go Preparing Hot Water on DemandTM for initial use. • Unpack your new water heater from the carton and make sure that all of the parts are included. If you find that one of the components is missing, please contact Coleman for a replacement. 1-800-835-3278 or TDD 1-316-832-8707.
To Set Up cont. • Installation of propane cylinder in Hot Water on DemandTM. • Use standard propane cylinders made for camping products. • Do not use 14.1oz cylinders normally used for hand torches. • Do not use MAPP gas cylinders or any other fuel except propane. • Make sure the control knob is turned “OFF ”. • Push in on the propane access door latch that is located on the left side of the door and swing door to opened position. Open the Propane Access Door.
To Set Up cont. • Close Front Propane Access Door • Rotate Faucet outward from the stored position and place a water collection basin under faucet. Use and Operation • Clean before first use. It is strongly recommended that you clean the heater prior to using for the first time. Follow these simple steps before you leave home, and then clean at least once a year or when the hose becomes discolored with a white calcium build up. Cleaning instructions: 1.
Use and Operation cont. Follow these simple steps for using Hot Water on DemandTM Complete Set-Up steps on previous pages. CAUTION Be cautious before plunging your hands into a basin of water by testing the temperature first. NOTE: Check electrical and quick connector before using Hot Water on DemandTM. Electrical Connection Quick Connector For Unheated Water • Rotate the faucet outward (Fig. 8). • Push and turn the control knob counterclockwise and position the knob at the “cool” setting (Fig. 9).
Helpful Hints • Due to the integrated mechanical and electrical over-temperature shut-off devices, Hot Water on DemandTM will not produce water that continuously exceeds 160°F. The burner will simply cycle off while the water keeps flowing for your convenience The burner will cycle back on when internal water temperatures reach about 120°F. • Hot Water on DemandTM is ideal for many outdoor cleaning tasks.
Troubleshooting Guide Symptom Problem Solution Yellow battery Low Light on during operation Battery voltage low Charge battery Battery defective Replace battery (refer to maintenance section for instructions) Propane cylinder empty Replace cylinder Propane cylinder frosted Replace cylinder and reuse after thawing Electronic circuit defective Send to Coleman Service Center Battery lead disconnected Remove battery cover & reinstall lead Pump is not positioned properly Rotate pump so “THIS SID
Replacement Parts Parts List No. 1 2 3 4 5 6 7 8 Part No. 2300-4071 2300-4081 2300-6251 2300-1481 2300-2111 2300-2201 2300-4061 2300-2051 Description 12 volt Recharger Cord (auto) 110 volt/120 volt Recharger Cord (household) Pump and Hose Quick-connect Pump Clip Battery Compartment Door Recharger Cord Compartment Door 6 volt Rechargeable Battery PCV Rain Cover - fits over Hot Water On DemandTM unit when not in use www.coleman.
Warranty Information 10 Year Limited Warranty The Coleman Company, Inc. (“Coleman”) warrants that for a period of ten years from the date of purchase, this product will be free from defects in material and workmanship. Coleman, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component.
Hot Water On Demand TM Accessories Spray Adapter 48” long hose easily attaches to faucet of Hot Water on Demand TM with Quick-connect fitting. Handled spray head is ideal for a light shower. Not Included Water Hose Adapter Regulates water pressure from input hose up to 100 PSI. Simply attach to Hot Water on DemandTM for a continuous water supply.