Application and Instruction Manual Motion Activated Solar Powered LED Security Light with Camera MODEL: XP-2H38WC
Please do not return this item to the store. If you have any questions, please contact Apex Digital directly (866.427.3946 or visit www.apexdigitalinc.com) Introduction Thank you for purchasing the Coleman solar powered security light (XP-2H38WC) with built-in wireless camera and microphone. This solar security light will allow you to illuminate and monitor activities in real time from locations up to 100 ft. from the included receiver.
What’s Inside the Package LED XP-2H38WC solar security light w/ Camera Mounting Screws Mounting Template Solar charging panel with 15’ Cable Receiver A/C Adapter (Receiver) Audio/Video connecting cables Owner/Installation Manual Features High efficiency, rechargeable Lithium battery. Detects motion at over 30 ft. Lithium-ion battery emits zero pollution, protecting the environment. High brightness illumination. Wireless broadcast of audio and video to a remote monitoring source.
3) Find a location for the solar panel that receives direct sunlight for a minimum of 4-6 hours a day and within 15’ of where the solar light will be installed. 4) Place the solar panel in desired location and secure with screws. 5) Completely insert the cable plug from the solar panel into the INPUT hole located at the bottom of the light. 6) Adjust the motion detection sensor and camera towards the desired coverage area. Functions & Adjustments OFF: No illumination; no camera.
Recharge Plug in the solar panel charger, and the battery will charge whether the switch is set to the OFF, ON or AUTO positions. You can also charge the light with an approved power adapter (9V, 1A AC adapter (not supplied). Warning: Only Xepa Technology rechargeable batteries should be used! Wireless Receiver Wireless Receiver Instructions Use AV cable supplied to connect to TV/Monitor Insert the 12V AC power adaptor into the power jack on the receiver, power it on.
Troubleshooting Guide Symptom Possible Solution • In AUTO mode, light illuminates only when motion is detected when it is dark. • Make sure solar panel plug is fully inserted. • In ON mode, light illuminates until battery is drained. The light will not illuminate • Make certain the battery plug is connected inside the battery compartment.
There is not a picture on the monitor or the picture is not clear and has a lot of noise • Please check and ensure that the power supply is working • The distance between the receiver and the transmitter should not exceed 50-100 meters. • There is not an obstacle between the two devices (a steel building, for example) • The antenna of the receiver must be far from copper, iron, walkie-talkie’s, radios and so on Specifications Rechargeable Battery: 3.
FCC Part 15 Class B & C CAUTION: Modifications are not approved by the party responsible for compliance and could void user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.