Owner`s manual

- - 13 -
Spa Functions
8. Up/Down keys The default set point water temperature is 98F. You can raise or lower the
water temperature by pressing the button on the control panel to the desired
temperature.
The "Set Point" icon indicates that the display shows the desired temperature,
NOT the current water temperature!
9. Pump key is used to turn pump on or to select between off, low and high speeds. Press
Pump key to turn pump on. A second press will change pump speed.
A built-in timer will turn pump off 20 minutes after it has been started unless the user does so
manually.
The “Pump” indicator lights up on keypad display when pump is on.
The “Pump” indicator lights up when the Pump is on,
and will flash when Pump is on low speed.
10. Light key Press the light key to turn light on. Press a second time to turn light off. If
equipped with an L.E.D light pressing the light button rapidly will advance to the next setting. A
built-in timer automatically turns light off after 2 hours, unless it has been manually deactivated
first.
The “Light” indicator lights up when light is on.
11. Programming Filter / Frequency cycles To program the filter cycles, you must enter
Duration and Frequency. Recommended settings are 1 Hr filtration 4 times daily.
Setting filter cycle duration; Press and hold Light key until
the display shows a D in the window.
Use Up or Down key to change settings.
0 = no filtration
24 = continuous filtration