Owner`s manual

- - 14 -
(Default: 2 hours)
Note: it’s not recommended to set this to “0”
During a filter cycle the pump runs on high speed for one minute to purge the plumbing then runs
at low speed for the remainder of the cycle.
Filter cycle frequency
Press the Light key again. The display will show F, Use Up or
Down key to change settings.
When the desired setting is displayed, press Light key to confirm. A
filter cycle will start immediately.
The “Filter” indicator lights up when a filter cycle is
on.
12. Automatic Smart Winter Mode
Our Smart Winter Mode automatically protects your system from the cold by turning the pump on several
times a day to prevent water from freezing in pipes in the event of a heater malfunction.
The “Smart Winter Mode” indicator lights up when the Smart Winter Mode is on.
Winterizing
For best results, drain tub as described below, then remove drain plug from bottom
of wet end (pump), flip tub on edge and roll until water stops coming out of jets. As
an alternative you may follow procedure below, HOWEVER IN NO INSTANCE IS
THE ROTOSPA WARRANTIED AGAINST DAMAGE CAUSED BY FREEZING.
1. Remove the filter cover, strainer and filter.
2. Use a siphon hose (eg: garden hose) to drain the Roto Spa completely. To start the siphon put the
hose over a jet while the pump is running on high speed until the hose starts draining, then place
the hose at the bottom of the foot well. TURN OFF THE POWER to the Roto Spa and let the tub
drain completely. Note: The larger the diameter and the shorter the hose the faster the tub will
drain. You may also use a submersible pump if available.
3. Use a wet/dry vacuum to blow any remaining water out of the jets by inserting hose into center
ring at bottom of filter canister. Then hold the vacuum over each jet to suction remaining water out
of lines.
4. Pour @ 2-4 litres of non toxic RV antifreeze into the center ring of the filter canister, turning the
pump on for AN INSTANT to quickly circulate the antifreeze, then top up again until antifreeze
comes out of the jets.
5. To restart the tub in the spring, fill the tub, run jets for several minutes, then empty and refill.
6. Lock the cover down. For added protection you can cover your spa with a good all weather spa
cover. This cover can be purchased through your local dealer.
Never allow the Roto Spa hot tub to run without water or in a low water situation.
This may damage components and void warranty