Product Manual

Collomix Rühr- und Mischgeräte GmbH Forced-action mixer
D-85080 Gaimersheim Collomatic XM
Page 10 Rev. 01-06 Ref.no.: 39.017
7.0 Trolley (accessory)
The trolley (accessory) is designed for loading and unloading the mixing tub to and from
the machine. At the same time the locking device on the trolley can be used to enable
thin-bodied material to be poured out wherever it is required.
7.1 Trolley assembly
7.2 Handling
First remove the two cable binders from the moving parts.
Fit the two handle ends and fasten each of them with a screw.
Tighten the two arms with the thumb screw
• Take hold of the trolley by both handles.
• Move the two tub mounts under the tub and hook them both into the two recessed
handles on the tub.
• Press against the axle with one leg. Make sure that the tub is correctly in place.
• Tilt the trolley towards you until you have the tub in balance.
• If you are processing thin-bodied materials you can pour them by applying the
locking device:
• Pick up the tub as described above. Then set the trolley down lengthwise on the floor.
The tub swings free.
• First set the tub stop to vertical. The hook on the tub holder extends over the edge of
the tub and holds it.
• Then turn the tub holder so that its handle is positioned vertically upwards. The tub is
now locked.
• Now lift the trolley again slowly. As soon as you have reached a certain angle the
material will flow out of the tub.
• Once you have finished pouring, set the trolley down again and release the tub
holder and tub stop.
Using the pouring device