User guide

28
4-4. Setup – DEVICE
In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below.
Navigate through the menu items using the mouse or the control button on the remote control and change
the value of the menu item.
Figure 4.4.1. Device Mode Setup Screen
Table 4.4.1. Menu Items in Device Setup Screen
Item
Description
ALARM OUT
Set the sensor, motion, and video loss for triggering alarm relay.
HDD Error and Video Loss can trigger beeping.
CONTROLLER & PTZ
Set the PTZ baud rate, protocol, and ID.
CHANNEL
Select specified channel for motion zone setup.
SPOT OUT
Set the spot out
MOTION ZONE
Select either Full Zone or Partial Zone for motion sensing.
MOTION SENSITIVITY
Set the motion sensitivity for the specified channel.
Control the motion sensitivity from 1 to 9.
KEY TONE
Enable/disable key tone.
REMOTE CONTROL ID
Select an ID of remote control.
1. Select ID number.