User guide

7-7-3. Device

Select Device to set Spot Out, Enable/Disable CVBS Out, motion zone.

 ALARM OUT: Set the sensor, motion, and video loss for triggering alarm relay HDD Error and

Video Loss can trigger beeping.

 CONTROLLER: Set the controller baud rate and ID.

 PTZ: Set the PTZ baud rate, protocol, and ID.

 MOTION: Setup the motion detection area and the sensitivity.

o SITE: Select the channel

o MOTION ZONE: FULL Zone or PARTIAL Zone

o MOTION SENSITIVITY: 1~9 (High sensitivity level)

 KEYTONE: Sets On or Off of Key Tone.

 REMOTE CONTROLLER ID: Sets an ID number on the supplied remote control for its identification.

 SENSOR: Select the type of each sensor.

7-7-4. Display

Select the DISPLAY tab to set the DISPLAY conditions.

These settings apply to all channels.

 OSD: Sets whether to display or not date and time as well as channel number on the screen.

 OSD CONTRAST: Adjust the character contrast on the screen.