RGBW PENDANT LIGHTING MANUAL Coloronix, Inc. 5461 West Jefferson Boulevard Los Angeles, California 90016 (323) 677-4242 http://www.rgbw.com Page 1—Coloronix RGBW Pendant Lighting Manual V1.
Coloronix, Inc. © 2011 Coloronix, Inc. All rights reserved. According to copyright laws, this manual may not be copied—partially, or wholly— without the written consent of Coloronix, Inc. Despite full effort to avoid any clerical or printing inaccuracies, Coloronix, inc. accepts no responsibility for any such inaccuracies to be found in this manual. Coloronix, Inc. 5461 West Jefferson Boulevard Los Angeles, California 90016 Tech Support: (909) RGBW-555 http://www.rgbw.
Contents Summary 4 Introduction 4 Scope 4 Who is this manual intended for? 4 Additional Supplies 4 Safety 5 Hazard Icon Key 5 Specifications 5 Planning for Installation 6 Unpacking 6 Preparation 6 Points to Consider About Data 6 Quick Step-by-Step Instructions 6 Setting Color Mode 7-8 DMX Color Mode 7 Color Ray Stand Alone Mode 8 Install Fixture 10 Troubleshooting Guide 11 Further Troubleshooting 11 Replacing Failed Fixture 11 Warranty Information 12 Page 3—Coloronix RGBW Pendant Lighting Manual V
Summary Introduction RGBW Color Changing Pendants are active, top-of-the-line color changing fixtures. They draw on solid-state elements in order to produce highlights and washes in architectural spaces. More specifically, “RGBW” is an acronym for “Red, Green, Blue, and White”. RGBW LED color mixing luminaires have the potential to produce 4.3 billion colors, and 16.7 million white light tones.
Safety Hazard Icon Key: The “ DANGER” icon means avoiding pending danger will result in serious injury, or death. The “ WARNING” icon means avoiding this warning may result may in serious injury, or death. The “ CAUTION” icon means not exercising caution here may result in minor to moderate injury, or property damage. The precautions are: DANGER: Not turning off the main power before wiring, installing, connecting, or disconnecting this product may result in serious injury, or death.
Planning for Installation Unpacking The pendant is shipped assembled with no additional assembly needed. Any optional accessories are included in the package. Use the packing list located on the outside of the box to ensure all accessories are included. Survey the unit to make sure the pendant is intact—not cracked or damaged. Any damages to the package or its contents are the buyer’s responsibility; please follow protocol for filing damage claims.
Setting Color Mode Dip Switch Inside Housing For installations requiring DMX control, set the personalized DMX address using the address table (Below) for address dip switch position settings. The Dip Switch Board can be found inside the Housing accessible below the ceiling. See figure. Note: Up to 57 unique 4-channel addresses can be set per DMX universe.
Color Ray Stand Alone Mode For application not using DMX control, user can access preprogrammed shows. The fixture’s on board computer has been pre-configured with ColorRay programs. No additional software or hardware is needed to access. Set the dip switch address for stand alone use (see table below).
Page 9—Coloronix RGBW Pendant Lighting Manual V1.
Install Fixture 1. Electrical Connection Connect field supply wires (120VAC or 24DC—see specifications) to driver input power leads using appropriately sized wire nuts. Hot to black, neutral to white, ground to green and bare copper wire (if applicable). 2. Data Connection Connect data cables in series. Note: Fixtures on a serial data link must be daisy chained in one single line. To comply with the EIA-485 standard, no more than 32 fixtures should be connected on one data link.
Troubleshooting Guide If does not light, check if: Electrical power is not connected. Electrical power is less than specific voltage. Electrical power is greater than specified voltage. If does not respond to DMX control signal, check if: DMX control device and RGBW are addressed differently. DMX cable is damaged. DMX control device is disconnected or not operating. DMX device needs to be restarted. LED fixture was not restarted after address change.
Warranty Information 3 YEAR PRODUCT LIMITED WARRANTY Coloronix, Inc. provides a warranty to LED fixtures in case of physical or assemblyrelated malfunctions. This warranty is valid up to three years from the product’s purchase date. Furthermore, Coloronix, Inc. offers to repair products with no charge for labor, or at its own discretion, may offer to replace parts at no charge. However, any labor to remove or install fixtures is not covered.
