SDS

ManualsBrandsColour Crete ManualsPaint1 gal. Sage Semi-Transparent Water-Based Concrete Stain

COLOUR CRETE™ MSDS

PAGE 1 OF 9

SAFETY DATA SHEET

Prepared to U.S. OSHA, CMA, ANSI and Canadian WHMIS Standards

PART I What is the material and what do I need to know in an emergency?

1. PRODUCT IDENTIFICATION

TRADE NAME (AS LABELED): COLOUR CRETE™

CHEMICAL NAME/CLASS: Aqueous Polymer Mixture

SYNONYMS: None

PRODUCT USE: Concrete Stain

SUPPLIER/MANUFACTURER'S NAME: Preserva Products Ltd.

ADDRESS: 12860 Earhart Avenue,

Auburn, CA 95602

EMERGENCY PHONE: 800-797-2537 M-Th, 9am-4pm PST

BUSINESS PHONE: 800-797-2537 M-Th, 9 am-4pm PST

EMAIL ADDRESS FOR PRODUCT INFORMATION: info@preservaproducts.com

DATE OF PREPARATION: April 14, 2015

NOTE: ALL WHMIS required information is included in appropriate sections based on the ANSI Z400.1-2004 format. This product has been classified in accordance with the hazard criteria of

the CPR and the MSDS contains all the information required by the CPR.

2. HAZARD IDENTIFICATION

GHS

Pictograms:

Signal Word:

Warning.

GHS Class:

Eye Irritant, Category 2.

Skin Irritant, Category 2.

Hazard Statements:

Causes eye and skin irritation.

Precautionary

Statements:

Wear protective clothing, gloves, eye, and face protection.

Do not eat, drink or smoke when using this product.

Wash hands thoroughly after handling.

Take off contaminated clothing and wash it before reuse.

Dispose of unused contents, container, and other contaminated wastes in accordance with local,

state, federal, and provincial regulations.

If in eyes: Rinse cautiously with water for several minutes and remove contacts if present and

easy to do. Continue rinsing and get medical attention if eye irritation persists.

If on skin: Wash with plenty of soap and water.

If swallowed: Rinse mouth and get medical attention if you feel unwell.

Emergency Overview:

Irritant.

Route of Exposure:

Eyes. Skin. Inhalation. Ingestion.

Potential Health Effects:

Eye:

Causes eye irritation.

Skin:

Causes skin irritation.

Inhalation:

Prolonged or excessive inhalation may cause respiratory tract irritation.

Ingestion:

May be harmful if swallowed. May cause vomiting.

Chronic Health Effects:

Prolonged or repeated contact may cause skin irritation.

Signs/Symptoms:

Overexposure may cause headaches and dizziness.

Target Organs:

Eyes. Skin. Respiratory system. Digestive system.

Aggravation of Pre-Existing

Conditions:

None generally recognized.

Summary of content (10 pages)

PAGE 1
SAFETY DATA SHEET Prepared to U.S. OSHA, CMA, ANSI and Canadian WHMIS Standards PART I What is the material and what do I need to know in an emergency? 1. PRODUCT IDENTIFICATION TRADE NAME (AS LABELED): CHEMICAL NAME/CLASS: SYNONYMS: PRODUCT USE: SUPPLIER/MANUFACTURER'S NAME: ADDRESS: COLOUR CRETE™ Aqueous Polymer Mixture None Concrete Stain Preserva Products Ltd.
PAGE 2
3. COMPOSITION and INFORMATION ON INGREDIENTS CHEMICAL NAME CAS # % w/v Proprietary Polymer 10.0-20.0% Proprietary Acrylate Copolymer 3.0-7.0% Proprietary Glycol Ether 1.0-5.0% Water and other trace or non-hazardous components. Each of the other components are not hazardous or are present in less than 1 percent concentration (0.
PAGE 3
All Spills: Decontaminate the area of the spill thoroughly using detergent and water. Do not mix with wastes from other materials. If necessary, discard contaminated response equipment or rinse with soapy water before returning such equipment to service. Dispose of in accordance with applicable international, national, state, and local procedures (see Section 13, Disposal Considerations). Dispose of recovered material and report spill per regulatory requirements.
PAGE 4
HAND PROTECTION: Wear nitrile rubber gloves or solvex gloves for routine industrial use for routine industrial use. Use triple gloves for spill response, as stated in Section 6 (Accidental Release Measures) of this MSDS. If necessary, refer to U.S. OSHA 29 CFR 1910.138 or appropriate Standards of Canada. BODY PROTECTION: Use body protection appropriate for task (e.g., coveralls or apron).
PAGE 5
PROPRIETARY GLYCOL ETHER: Open Irritation Test (Skin-Rabbit) 500 mg: Mild Standard Draize Test (Eye-Rabbit) 100 mg: Severe Standard Draize Test (Eye-Rabbit) 100 mg/24 hours: Moderate LDLo (Oral-Human) 143 mg/kg TDLo (Oral-Woman) 600 mg/kg: Behavioral: coma; Lungs, Thorax, or Respiration: dyspnea; Nutritional and Gross Metabolic: metabolic acidosis TDLo (Oral-Woman) 7813 µL/kg: Behavioral: coma; Vascular: BP lowering not characterized in autonomic section; Nutritional and Gross Metabolic: metabolic acidosis
PAGE 6
11. TOXICOLOGICAL INFORMATION (Continued) TOXICITY DATA (continued): PROPRIETARY GLYCOL ETHER (continued): TDLo (Oral-Rat) 1575 mg/kg/7 days-intermittent: Liver: other changes; Blood: other hemolysis with or without anemia, changes in spleen TDLo (Oral-Mouse) 5180 mg/kg/2 weeks-continuous: Endocrine: changes in thymus weight TDLo (Oral-Mouse) 9440 mg/kg/8 days-intermittent: Related to Chronic Data: death TDLo (Oral-Mouse) 198.45 gm/kg/21 weeks-continuous: Related to Chronic Data: death TDLo (Oral-Mouse) 37.
PAGE 7
11. TOXICOLOGICAL INFORMATION (Continued) REPRODUCTIVE TOXICITY INFORMATION (continued): A mutagen is a chemical that causes permanent changes to genetic material (DNA) such that the changes will propagate through generational lines. An embryotoxin is a chemical that causes damage to a developing embryo (i.e. within the first eight weeks of pregnancy in humans), but the damage does not propagate across generational lines.
PAGE 8
15. REGULATORY INFORMATION (Continued) ADDITIONAL U.S. REGULATIONS (continued): CALIFORNIA SAFE DRINKING WATER AND TOXIC ENFORCEMENT ACT (PROPOSITION 65): No component of this of product is on the California Proposition 65 lists. ADDITIONAL CANADIAN REGULATIONS: CANADIAN DSL/NDSL INVENTORY STATUS: The components of this product are listed on the DSL Inventory. OTHER CANADIAN REGULATIONS: Not applicable.
PAGE 9
DEFINITIONS OF TERMS (Continued) HAZARDOUS MATERIALS HAZARD RATINGS (continued): IDENTIFICATION SYSTEM NATIONAL FIRE PROTECTION ASSOCIATION HAZARD RATINGS (continued): FLAMMABILITY HAZARD (continued): 3 (Serious Hazard- Liquids and solids that can be ignited under almost all ambient temperature conditions.
PAGE 10
DEFINITIONS OF TERMS (Continued) NATIONAL FIRE PROTECTION ASSOCIATION HAZARD RATINGS (continued): INSTABILITY HAZARD (continued): 3 Materials that in themselves are capable of detonation or explosive decomposition or explosive reaction, but that require a strong initiating source or that must be heated under confinement before initiation: Materials that have an estimated instantaneous power density (product of heat of reaction and reaction rate) at 250°C (482°F) at or above 100 W/mL and below 1000 W/mL.