Service manual

25
in.xe
Programming the in.xe
using the keypad
Although every in.xe spa pack
is factory set, in certain cases
when servicing or replacing
a new unit in the fi eld, it may
be necessary to set a new pre-
determined low level program
confi guration into the spa pack.
Follow this simple steps to
re-enter the low level pro-
gramming menu using the
keypad:
Press and hold the Pump
1 key
for 30 seconds.


Use the Up/Down key to
choose the new desired low
level confi guration number
and press the Program key
to confi rm the selected
confi guration (consult the
confi guration selection chart
section in this manual).
If the Program key is not
pressed within 25 seconds, the
unit will exit this menu without
changing any settings.
If at power-up of the system
your keypad display shows
the following message:
"L _ _
", it means that all low
level confi gurations have
been downloaded, but no
confi guration number has
been chosen.
Note: If the keypad in use does
not have the Program key, use
the Light key instead.
The keypad display will show
L xx where "xx" represents the
previous confi guration number
registered in the system.
Programing the in xe