Service manual

27
in.xe
in.xe programing field options
In the event where none of the pre-determined low level program
configurations built in the in.xe system suit your spa equipment
assembly, it's possible to custom configure the in.xe system by
manually entering key parameter settings.
Parameter Display Options Description
Pump 1 Config
Single-speed = 1
Dual-speed = 2
Pump #1 configuration
Pump 2 Config
Not installed = 0
Single-speed = 1
Dual-speed = 2
Pump #2 configuration
Blower Config
Not installed = 0
Installed = 1
Blower configuration
Circ. Pump Config
Not installed = 0
Installed = 1
Always on = 2
Circulation Pump configuration
Ozone Config
Not installed = 0
During filter cycle = 1
Always on = 2
Ozone generator configuration
Ozone Pump
Circulation pump = 0
Pump #1 = 1
Pump associated to Ozone generator
Ozone Type
Standard = 0
Timed = 1
Type of Ozone generator
Heater Pump
Circulation pump = 0
Pump #1 = 1
Pump associated to Heater
Programing the in xe
To access this menu, press and hold Prog. (or Light key) for 30
seconds. Use Up or Down key to choose setting.
Press Progr. key (or Light key) to go to the next parameter.