Specifications

19
in.k450 for in.xm spa systems functions and user instructions
Setting the time
Enter Programming mode by
holding Prog. key pressed down
for 3 sec. The display will show
the current time setting.
Setting the hour: Use Up or
Down key to change hour
setting (AM/PM).
Setting the minutes: Press Prog.
key a second time.
Use Up or Down key to change
hour setting.
Setting filter cycle start time
To program the filter cycle, you
must enter these parameters:
the start time, duration and
frequency. During a filter cycle,
pumps run for one minute
to purge the plumbing, then
Pump 1 runs for the program-
med number of hours.
Press Prog. key a third time.
The display will show FSxx,
with "xx" representing the
starting hour.
Use Up or Down key to
change setting.
Setting filter cycle duration
Press Prog. key a fourth time.
The display will show Fdxx, with
"xx" representing the duration
in hours.
Use Up or Down key to
change setting.
0 = no filtration
1
24 = continuous filtration
1
It's not recommended to
set this to "0".
Program key
Use Program key to display
time or enter Programming
menu by pressing and holding
key. In Programming mode,
the following parameters can
be set: time, filter cycle start
time, filter cycle duration,
filter cycle frequency, and
temperature unit.
Note: Light key is used as
Program key if this key is
not present.