User manual

Capricorn 2000EX Weather Station 57
___________________________________________________________________
Columbia Weather Systems, Inc.
Example:
11:00 Time
02/11/2007 Date
50.14 Degrees F Temperature 1
70.89 Degrees F Temperature 2
68.33 Degrees F Temperature 3
64.46 Degrees F Temperature 4
29.88 Inches Hg Barometric Pressure
006 MPH Wind Speed
SE Wind Direction
073 Percent Relative Humidity
00.06 Inches Rain (Today)
04.43 Volts Leaf Wetness
01.30 Volt X1
04.58 Volts X2
ok
The SAMPLE command
SAMPLE: This command is used to display the current sensor readings
in a one line record format (the same format as the datalog). The record
starts with the letter S followed by the date and time of the sample,
followed by the sensor values and ends with a check sum value. All of
these fields are comma delimited.
Example:
S,02/11/98,11:09,36WD,003WS,00.06R,072RH,29.88P1,+050.59T1,+070.77T2,+068.23T3,+064.6
0T4,04.43LW,0.00X1,0.00X2,6007ok
Where, WD is wind direction, WS is wind speed in MPH, R is rain fall in
inches, RH is relative humidity percentage, P1 is barometric pressure in
Inches-Hg, T1 through T4 are the four temperature sensors in degrees F,
LW is leaf wetness in volts, X1 is typically solar radiation (5.00 volts
equals 2000 Weather Master 2000-2) and X2 is used for additional
sensors (X1 and X2 are available only in the Capricorn 2000MP).
Temperature sensors that are not defined or connected will have a
+255.00 reading.
Wind direction is displayed in a 64 degree compass (1 = 5.625 degrees).
For example:
Degrees
0 N 0
4 NNE 22.5
8 NE 45
12 ENE 67.5
16 E 90
20 ESE 112.5
24 SE 135