User manual

46 Capricorn II Plus User Manual
E. WIND SENSOR MAINTENANCE
Do not attempt to oil, grease or otherwise lubricate the wind sensors. The wind
speed and direction bearings are permanently sealed and should not be tampered
with. If it appears that the displayed wind speed values are substantially less than
existing conditions, or that the wind direction display is sluggish in responding to
changes in wind direction, it may be that the bearings need service. This can be
tested by spinning the sensors. They should spin freely. If they do not, call the
factory for service. All or part of the wind sensors may need to be replaced. Since
the circuit is molded into the wind sensor housing, an electronic defect requires
replacement of the sensor. The wind sensors are not designed for field repair.
In the event the wind speed or wind direction displays do not light, display “0” con-
stantly regardless of wind conditions, or are erratic, either the console or the sensors
(or both) may be defective. Refer to Section 8: Troubleshooting for recommended
tests that will help locate the source of the problem.