User`s guide

Virtual Weather Station User's Guide
-14- 04/10/07
or the complete record mode (Peet Bros Station only).
Figure 6 - Communication Settings
6.6.6 Sensor and Battery Status (WMR-918 and
WMR-968 only)
Menu Shortcut: Communication X Sensor
Communication
6.6.6.1 Active
Only check the sensors that are active in your system. If a
sensor fails to report or is not part of your system, uncheck
the sensor active checkbox.
6.6.6.2 Comm OK
After communication with the WMR-918 or WMR-968
weather station is detected, a green LED will be displayed.
After all of the remote devices have reported, this window
will automatically close.
Virtual Weather Station will begin updating when all of the
sensors have reported (can take up to one minute). Note
that if a sensor is not reporting, it can be deactivated to
continue running Virtual Weather Station.
6.6.6.3 Battery OK
A status LED will provide you with the status of the remote
sensor batteries. If the LED is red, it is time to change the
batteries. If the station is not reporting, the battery may be
low or interference is present.
To allow Virtual Weather Station to execute without the
sensor, inactivate the "problem" sensor by deselecting the
Active checkbox.
Figure 7 - Sensor Communication (WMR-918 and
WMR-968 only)
6.6.7 WMR-100 Sensor and Battery Status
Menu Shortcut: Communication X WMR-100 Sensor
Communication
6.6.7.1 Check Active Sensors Only
Only check the sensors that are active in your system. If a
sensor fails to report or is not part of your system, uncheck
the sensor active checkbox.
6.6.7.2 Battery OK
A status LED will provide you with the status of the remote
sensor batteries. If the LED is red, it is time to change the
batteries. If the station is not reporting, the battery may be
low or interference is present.
6.6.7.3 Comm OK
After communication with the WMR-100 weather station is
detected, a green LED will be displayed. After all of the
remote devices have reported, this window will
automatically close.
Virtual Weather Station will begin updating when all of the
sensors have reported (can take up to one minute). Note
that if a sensor is not reporting, it can be deactivated to