Specifications

LWLCWH COLUMBIA BOILER COMPANY REV. 13106
29
Alkalinity
The alkalinity of boiler water should be sufficiently high enough to protect shell and plates against
acidic corrosion, but not high enough to produce carryover. A minimum value for alkalinity for ade-
quate protection is 200 PPM.
High boiler alkalinity, which is in excess of 700 PPM. should be avoided. Values higher than this can
lead to embrittlment of the steel.
Phosphates
Phosphates are used to react with calcium hardness in the boiler water. In order for this reaction to
take place it is important to maintain a pH at a minimum value of 9.50. It is desirable to keep the con-
centration of phosphates in the water to 30-50 PPM in order for complete reaction of the phosphates
with the calcium hardness entering the boiler through the feedwater.
Hardness
The hardness of water is caused by calcium and magnesium ions which will vary greatly throughout
the country depending on the source of the water.
In boilers the hardness of the water can cause the formation of scale and sludge or mud. The hard-
ness must be removed in the makeup water to the return system. Total hardness should not exceed
50 PPM.
Oils
Every effort should be made to prevent oils from getting into the boiler water. Oil causes foaming, or
combines with suspended solids to form a sludge which can cause the overheating of boiler plates.
If oil does get into the boiler, the boiler should be taken out of service immediately, and thoroughly
cleaned.