User`s guide

10 DOXport 1110 User’s Guide
3. Select the Configuration tab on the Network window.
4. Check to see if TCP/IP has been installed for the Ethernet card. If TCP/IP
appears in the list of network components, it is installed. Select it and proceed
to step 8. If it doesn't appear on the list, click Add and continue with step 5.
5. Double-click the PROTOCOL option on the SELECT NETWORK
COMPONENT TYPE window (Figure 13).
6. Click MICROSOFT in the MANUFACTURERS section and then click
TCP/IP in the NETWORK PROTOCOL section on the SELECT
NETWORK PROTOCOL window (Figure 14).
7. Click OK.
Figure 13.
Select Network Component Type Window
Figure 14.
Select Network Protocol Window