User manual

User Manual coM.sat PCI GSM
Created on: 18.01.2010 Page | 4
Please observe security references as per DIN 34! User manual PCI-GSM V1.1
1.4.7 Transportation
The packaging provided by deliverer when receiving the equipment does not
guarantee full protection against crushing and beating during transportation.
Therefore an additional packaging should be provided for further transportation. In
case the equipment was stored within a cold environment, it should slowly be
warmed up until it reaches ambient temperature, in order to avoid humidity
issues.
1.4.8 Installation location for equipment
The installation location for the equipment should avoid direct sunlight as well as
heat. Respecting of this directive will help increase the reliability of operation as
well as their durability, as the components have to endure less temperature
influences. The cabling for the equipment should be done in a way to avoid any
physical damage to the people who will be handling the systems. Network-cabling
should be separated from the cabling for signaling. The installation of the
equipment should only be done by adequately trained manpower.
1.4.9 Damage or repair
When noticing damages on the equipment or if it has been exposed to humidity,
further operation of it should be avoided due to security reasons. Repairs should
only be done by the manufacturer or through an authorized representation. In any
case the equipment shall be disconnected from power supply before any repair
work is initiated.