Operation Manual

CHOOSING AND USING THE BRUSHES

POLYPROPYLENE BRUSH (PPL)

Used on all types of floors. Good resistance to wear and tear, and hot water (no greater than 60°C). The Polypropylene brush is non-hygroscopic and

therefore retains its characteristics even when working in wet conditions.

PAD HOLDER

The pad holder is recommended for cleaning shiny surfaces.

There are two types of pad holders of the CENTER LOCK type, equipped with a snap-type central locking system in plastic that allows the abrasive

floor pads to be perfectly centred and held without any risk of them becoming detached:

1. fitted with a series of anchor points that allow the abrasive floor pad to be held and dragged while working

2. fitted with a series of groups of bristles that allow the abrasive floor pad to be held and dragged while working

TABLE FOR CHOOSING THE BRUSHES

Machine No. of

brushes

Code Type of bristles Bristles  Brush Notes

VISPA 1

421701

422213

422001

PPL

Pad holder – anchor

Pad holder – bristles

0.6

0.9

355

MACHINE DISPOSAL

To dispose of the machine, take it to a demolition centre or an authorised collection

centre.

Before scrapping the machine it is necessary to remove and separate the following

materials and send them to the appropriate collection centres in accordance with the

environmental hygiene regulations currently in force:

• brush

• filter

• electric and electronic parts*

(*) In particular, to scrap the electric and electronic parts, contact your area distributor.