User Manual

Powering On and Off

This chapter covers connectors and switching on and off.

Switch On

PLEASE ENSURE THE ANTENNA HAS BEEN FITTED.

IT IS ESSENTIAL TO AVOID DAMAGE.

1. Plug the Gateway AC adaptor into the socket on the underside of the Gateway, or for the PoE model (RF500AP)

plug the ethernet cord into a PoE enabled network socket . The Power/Battery indicator should show steady green.

2. Using a paper clip or similar object, press in and hold the ON/OFF switch on the side of the Gateway for 4 seconds.

Refer to “Figure 3 – Left Hand Side View of Gateway”. The Gateway will beep once and the On/Off indicator shows

flashing blue. Gateway initialisation will begin.

The Gateway contains an internal backup battery, if this battery is not sufficiently charged, the Gateway will not

switch on. Once external power is connected the internal battery will begin recharging. Whenever the charge

state becomes sufficient the Gateway will automatically start as requested. TO BE CHANGED Whilst in this

mode Status LEDs 2, 3 and 4 will flash together. See Figure 3 – Left Hand Side View of Gateway for location

of these LEDs.

It takes a few minutes for the Gateway to initialise. A sequence of 2 beeps followed by 4 beeps indicates

successful initialisation.