User Manual

Powering On and Off
Gateway Switch OFF
To turn the Gateway OFF navigate to the hardware page of the website and use the Shutdown Gateway button, this will
initiate the Gateway shut-down procedure.
If for some reason it is not possible to use the Shutdown Gateway button, press and hold the ON/OFF switch for 4
seconds. The Gateway will beep once and the On/Off indicator will flash to indicate shut-down. This will initiate an orderly
shut-down of the Gateway at the start of which, the Gateway will beep 50 times in quick succession. The shut-down
procedure could take up to 5 minutes to complete. After shut-down is complete the On/Off indicator extinguishes.
Gateway Reset
There are several circumstances under which the Gateway will perform a software reset. At start of the sequence the
Gateway will beep 50 times in quick succession. The reset could take up to 5 minutes to complete which is indicated by a
sequence of 2 beeps followed by 4 beeps to indicate successful initialisation. Unlike the shut-down described above, the
On/Off indicator will remain steady during the reset sequence.
Transmitter Activation
RF500 Transmitters are despatched in a disabled state to preserve the battery. To activate these, insert the RF525
Activator into the 3-pin socket marked B in “Figure 5 - Connector view of RF512, RF515 & RF516 Transmitter” until the
display is enabled then remove the RF525.
Once activated, Transmitters can only be de-activated by removing the battery.
21