User Manual

Gateway Commissioning
Network Setup
The Network Settings page has many fields but at this stage for a basic LAN connectivity test, only the Network Details
section is required.
1. Click Administration button then the Setup Network button.
Network Details
Usually the IT Department will allocate a static IP address and subnet mask for the Gateway. Enter these using dotted
decimal notation into their respective fields. If access from different subnets is required also enter the Network Gateway
IP address. Users who implement MAC address access security will find the MAC address of the LAN interface displayed
in this screen.
Static IP Address The IP address which has been allocated to the Gateway. E.g.
192.168.25.217
Net mask The subnet mask associated with the above IP address. E.g.
255.255.255.0
Default Gateway The IP address of the network gateway to allow access by users on a different subnet
DNS no The IP address of your LAN Name Server
2. Double-check the Static IP Address entered because any entry mistake here can cause problems connecting after
settings are saved.
3. To save changes, enter your Gateway password and click the Save button. The Gateway may automatically reset
after this step.
4. Remove the cross-over ethernet cable after the Gateway has reset. (See Gateway Reset)
28