User Manual
Table Of Contents
- RF500 LITE System Components
- Safety Information
- RF500 LITE Wireless Monitoring System Overview
- Equipment Installation
- Powering On and Off
- Gateway Commissioning
- Gateway Programming and Use
- Gateway Specification – RF500 LITE
- Transmitters Specification – RF512, RF513 and RF516
- Changing Lithium Battery on RF512 Series Transmitters
- Pinout and Wiring
- FCC Approvals
- Equipment Ratings
- Maintenance and Cleaning
- Declaration of Conformity
- Transmitter Error Codes
- Gateway Fault Conditions
- Definitions of Gateway Terminology
- Glossary
- Document Revision History
Safety Information
Under no circumstances may a user make any changes to the RF500 LITE Gateway that
would alter its performance. Any modification would void the CE compliance of the Gateway
and may invalidate any warranty.
If the equipment is used in a manner not specified by Comark, then the protection provided by
the equipment may be impaired.
No user serviceable parts are provided in RF500 LITE Comark Wireless Monitoring
Equipment. Contact Comark or your local distributor for all service requirements.
Warning
• Use only the Linearity Electronics 12V mains adaptor; Model LAD6019AB5, or Stontronics
12V mains adaptor; Model T3068LN with the RF500 LITE Gateway.
• Do not modify the Linearity Electronics 12V mains adaptor; Model LAD6019AB5, or
Stontronics 12V mains adaptor; Model T3068LN in any way.
• Use only the PHIHONG, PSM11R-050 5V mains adaptor with RF512 and RF513. It is
supplied by Comark Limited as three variants:
RF520 Transmitter mains adaptor with UK plug
RF520/EU Transmitter mains adaptor with European style plug
RF520/US Transmitter mains adaptor with North American style plug
• Do not modify the PHIHONG, PSM11R-050 5V mains adaptor in any way.
• Do not connect any mains adaptor to RF516. CE compliance is invalidated by this action.
• RF512, RF513 and RF516 Transmitters contain a C-size lithium cell. This cell must not be
incinerated or subjected to temperatures in excess of 100°C. Do not deform, mutilate,
crush, pierce, disassemble, recharge or short circuit. Such abuse can result in loss of seal,
and/or cell explosion. Also exposure to humid conditions for long periods should be
avoided.
• Do not insert metal objects into connectors.
• Ensure the antenna is securely connected before powering the equipment. Internal
damage may result otherwise.