User Manual
Table Of Contents
- RF500 LITE System Components
- Safety Information
- RF500 LITE Wireless Monitoring System Overview
- Equipment Installation
- Powering On and Off
- Gateway Commissioning
- Gateway Programming and Use
- Gateway Specification – RF500 LITE
- Transmitters Specification – RF512, RF513 and RF516
- Changing Lithium Battery on RF512 Series Transmitters
- Pinout and Wiring
- FCC Approvals
- Equipment Ratings
- Maintenance and Cleaning
- Declaration of Conformity
- Transmitter Error Codes
- Gateway Fault Conditions
- Definitions of Gateway Terminology
- Glossary
- Document Revision History
Powering On and Off
This chapter covers connectors, switching on and off.
Switch On
PLEASE ENSURE THE ANTENNA HAS BEEN FITTED.
IT IS ESSENTIAL TO AVOID DAMAGE.
The RF500 LITE is configured to automatically initialise once mains power is
detected.
1. Plug the Gateway mains adaptor into the socket on the underside of the Gateway. The
Mains/Battery indicator should show steady green and Gateway initialisation will begin.
2. (Assuming the Gateway has been switched off) Using a paper clip or similar object, press
in and hold the ON/OFF switch on the side of the Gateway for 1 second. Refer to “Figure
3 – Left Hand Side View of Gateway”. The Gateway will beep once. Gateway initialisation
will begin.
It takes a few minutes for the Gateway to initialise. A sequence of 2 beeps followed
by 4 beeps indicates successful initialisation.
Gateway Switch OFF
To turn the Gateway OFF navigate to the hardware page of the website and use the
“Shutdown Gateway” button, this will initiate the Gateway shutdown procedure. If for some
reason this is not possible to do this power can be removed from the Gateway (but this is not
recommended).
Transmitter Activation
The RF512, RF513 and RF516 transmitters are despatched in a disabled state to preserve the
battery. To activate these insert the RF525 Activator into the 3-pin socket marked B in “Figure
5 - Connector view of RF512 & RF516 Transmitter” until the display is enabled then remove
the RF525.
Once activated, transmitters can only be de-activated by removing the battery.
i
i