User Manual
Table Of Contents
- RF500 LITE System Components
- Safety Information
- RF500 LITE Wireless Monitoring System Overview
- Equipment Installation
- Powering On and Off
- Gateway Commissioning
- Gateway Programming and Use
- Gateway Specification – RF500 LITE
- Transmitters Specification – RF512, RF513 and RF516
- Changing Lithium Battery on RF512 Series Transmitters
- Pinout and Wiring
- FCC Approvals
- Equipment Ratings
- Maintenance and Cleaning
- Declaration of Conformity
- Transmitter Error Codes
- Gateway Fault Conditions
- Definitions of Gateway Terminology
- Glossary
- Document Revision History
Gateway to PC Network Connection via RJ45 cross-over Ethernet Cable
Connect the cross-over Ethernet cable between PC and RJ45 jack on the Gateway.
Set up your PC temporarily with a fixed IP address.
You should undo these steps once you have completed commissioning the Gateway.
For Windows 98, ME, 2000 and XP
1. Go to the Windows control panel and double-click on the Network icon or the Network
Connections icon
2. Right-click on the “Local Area Connection” and select Properties
Figure 8 – Local Area Connection Properties
3. In the General Tab select the “Internet Protocol TCP/IP” item and click on the Properties
button