User Manual
Table Of Contents
- RF500 LITE System Components
- Safety Information
- RF500 LITE Wireless Monitoring System Overview
- Equipment Installation
- Powering On and Off
- Gateway Commissioning
- Gateway Programming and Use
- Gateway Specification – RF500 LITE
- Transmitters Specification – RF512, RF513 and RF516
- Changing Lithium Battery on RF512 Series Transmitters
- Pinout and Wiring
- FCC Approvals
- Equipment Ratings
- Maintenance and Cleaning
- Declaration of Conformity
- Transmitter Error Codes
- Gateway Fault Conditions
- Definitions of Gateway Terminology
- Glossary
- Document Revision History
Adding Transmitters
Click Administration button then the Transmitters button.
A categorised list of transmitter serial numbers is displayed. Click the Add New button, a form
will be presented as follows:
Serial Number Enter the serial numbers of the transmitters provided for your
installation. Note that the serial numbers are case sensitive, i.e.
BA03060001 is correct, ‘Ba’, ‘bA’ or ‘ba’ is incorrect and will not be
recognised
Make this a Backbone unit (RF512 and RF513 only)
Those transmitters which have been identified as Backbone units
during the site survey must have this box ticked. Do not tick this
box for transmitters which have no mains adaptor connected
Disable Display Tick this option to disable the LCD for those transmitters where the
local display is not required
Radio Tx rate This setting controls the rate at which batches of readings are
transmitted to the Gateway. A drop-down-list of minute intervals is
presented, choose a default of 15 minutes unless a faster update
rate is necessary. Updating faster than 15 minutes has a
detrimental effect on battery life
Add to Location Choose an administrative Location for this transmitter. Locations
are described fully in the Gateway Web-View Help Guide
Enter your password and click the Save button. The newly added transmitter will be added to
the categorised list.