User Manual

Survey Kit Overview
The Survey Kit is designed to enable evaluation of a potential RF500 customer premises. The Kit
enables the user to identify critical RF “choke points” and strategic locations for “meshing” units
making the actual RF500 install a smooth and trouble free process.
Equipment Use
Powering On and Off
PLEASE ENSURE THE ANTENNAS HAVE BEEN FITTED.
IT IS ESSENTIAL TO AVOID DAMAGE.
RF505
The RF505 does not have an on/off button, simply plug it into a free USB port on your computer
(Fig.5) and the device will power up and immediately begin to operate.
RF512 Survey Transmitters
To activate the survey transmitters plug the attached 3 pin activation key into port A (Fig.4), the two
activity LED's (Fig.3) should begin to flash. To deactivate the survey transmitters simply remove the
activation key and the transmitter will shut down after a few moments.
Equipment Setup
Figure 5 – RF505 → PC Connectivity
Using the cable provided connect the RF505 to a free USB port on your laptop PC. The green
“Active” LED (Fig.1) will now illuminate and the gateway is ready for use. Start the Ember Studio
software and proceed as the RF500 Survey Manual indicates.
6