User's Manual

4. Reconnect the codes (of the mouse and the receiver).
Misuse of the mouse
The reason for misuse of the mouse is that the mouse automatically encodes the codes when
replacing the batteries. In the event that your PC is operated with another mouse, reconnect
the codes.
In case that several mice are used in the same room, the mice cannot be
detected.
The root cause for the problem is multiplex refreshing failure. Take the following actions to
avoid such problem:
1. Reduce the distance between the mouse and the receiver, and the distance should never
exceed 1.0m.
2. For different mice, press the CONNET button on the receiver and the mice in different
time to reconnect the codes.
Disclaimer
We made every effort to ensure that the information and procedure in this guide is accurate
and complete, no liability can be accepted for any errors or omissions and reserves the right
to make any changes without further notice to any products herein.
Warning
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
--Consult the dealer or an experienced radio/TV technician for help.
Label: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions (1) This device may not cause harmful
5