Datasheet

CODICE – CODE:
CE0467
CARATTERISTICHE ELETTRICHE E
MECCANICHE
Electrical & Mechanical Specifications
FOGLIO - SHEET:
3 of 10
DATA – DATE:
12-03-2010
All parts included in this documentation are property of
COMATEC snc. All rights reserved. This document and
its information (or part of its) can't be reproduced or used
without an explicit written permission.
All technical specifications are
subjected to change without notice.
EDIZIONE – ISSUE:
1
st
Edition
CARATTERISTICHE D'INGRESSO Input Requirements
Tamb=25°C, f=50Hz se non specificato altrimenti Tamb=25°C, f=50Hz unless otherwise specified
N° PARAMETRO
Parameter
CONDIZIONI
Conditions
MIN TYP MAX UNITÀ
Unit
1 Input Voltage
Range
100-240 (+/- 10%) Vac
2 Input Frequency
Range
50 60 Hz
3 Input Current Full load; Vin=100Vac; Vout=24V
No load; Vin=230Vac; Vout=28V
Full load; Vin=230Vac; Vout=24V
0.95
20
0.51
Arms
mArms
Arms
4 Inrush Current Full load; Vin=265Vac; deg=0°
Full load; Vin=265Vac; deg=90°
Full load; Vin=265Vac; deg=270°
13 (6.0 ms)
24 (2.5 ms)
22 (2.5 ms)
Apk
Apk
Apk
5 Protection in the
mains supply line
Standard EN60898
Standard EN60947-2
3A Char. C
10A Char. Z
6 Power Factor Vin=100-240Vac; full load 0.46 0.60
7 Efficiency Vin=100Vac; full load
Vin=230Vac; full load
86
89
%
%
8 No Load Input Vin=100Vac; No load; Vout=28V
Vin=230Vac; No load; Vout=28V
1.4
0.9
W
W
Note1: The range of source voltage for which the power supply is guaranteed to meet its specifications.
Note2: The range of source frequency for which the power supply is guaranteed to meet its specifications.
Note3: The maximum value of the steady state AC input current, measured for any combination of rated AC
voltage and environment and for any combination of rated continuous output loading (up to a maximum of
Watts).
Note4: The high surge of input current that occurs upon initial turn-on, after an OFF period of at least
10 seconds.
Note5: The connection to the mains line should be made using an all-pole mains switch (with a contact
separation of at least 3mm in each pole) with the shown characteristics.
Note6: The ratio of actual power used in a circuit to apparent power, for any combination of AC input
voltage. Power factor is the measure of the fraction of current in phase with the voltage and
contributing to average power.
Note7: The ratio of output power to input power, measured at full load and for any combination of the
rated AC input voltage.
Note8
: The input power, measured without load.