User's Manual

INSTALLATION GUIDE FOR UHF DAS
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 31
3.3.11 DC POWER AND MONITOR CABLE CONNECTION BETWEEN EU AND EU
Figure 21: DC power and Monitor cable connection for EU
⚫ Power Cable：OUT+→IN1+，OUT-→IN1-；
⚫ Monitor Cable：ADD_OUT→ADD_IN；
⚫ RJ45 Cable：AUX3→AUX1。
3.3.12 RF CABLE CONNECTION
UHF PS DAS RF cables connection is as follows:
⚫ UHF PS DAS MU DT/DL IN port → Connects to the feeder cable from the donor antenna.
⚫ UHF PS DAS MU MT/DL OUT port → Connects to the feeder cable from the service antenna infrastructure.
⚫ UHF PS DAS MU IN1/OUT1 ports → Connects to UL1/DL1 or UL2/DL2
⚫ UHF PS DAS RU MT port → Connects to the feeder cable from the service antenna infrastructure.
3.3.13 WEB ACCESS
Connect ‘OMT’ or ‘LAN’ using regular Ethernet cable, then use the correct IP address in the browser to access to the
WEB GUI
3.3.14 DRY CONTACT CABLE
Below please find the pin definitions of Dry Contact Cables.
Table 4: Pin Definition of Dry Contact Cable
Pin NO.
Pin
Input
ALM1
Power Cable
Monitor Cable
RJ45 Cable
EU 1
EU 2