User's Manual

USER MANUAL FOR COMFLEX-4300
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 22
Step 4: Finish installation.
Figure 13: Finish Installaiton
3.3.6 RU WALL MOUNTING
RU wall mounting steps are shown below.
Step 1: Select the wall mount location according to the following criteria:
 General surroundings
 Ventilated and easy-to-reach area (for maintenance and on-site inspection)
 Proximity to DAS antenna in order to minimize cable loss
Step 2: Using the mounting bracket top and bottom mounting holes as a guide
 Measure and mark the location for drilling the (supplied) M10 Masonry bolts (Φ12) in the wall
(6 per bracket and drill the holes).
 Using an electric drill with a Φ12 head, drill the holes for the Masonry Bolts.
NOTE: The ComFlex remote unit is mounted vertically with the connectors facing downwards.
Step 3: Using 6 (M10x110) Masonry bolts per bracket – secure the Mounting Brackets to the wall with the
protruding M8 nuts facing towards you. The remote unit will be hung on these.