User's Manual

USER MANUAL FOR COMFLEX-6800
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 18
Manual Handling
During transportation and installation, take necessary handling precautions to avoid potential physical
injury to the installation personnel and the equipment.
3.2.2 SYSTEM INSTALLATION CHECKLIST
 Working space available for installation and maintenance for each mounting arrangement. Ensure
unrestricted airflow.
 Ensure earthing point is within reach of the ground wire. (2m; 6 ft. 10 in.).
 Ensure a power source is within reach of the power cord and the power source has sufficient
capacity.
 Where appropriate, ensure unused RF connectors are terminated.
 Where appropriate, ensure unused optical fiber connectors are protected.
 Do not locate the equipment near large transformers or motors that may cause electromagnetic
interference.
 Reduce signal loss in feeder cable by minimizing the length and number of RF connections.
 Ensure the equipment will be operated within the stated environment (refer to datasheet).
 Where needed, couple BTS RF signal with a coupler to prevent damaging the equipment.
 Where appropriate, confirm available of suitably terminated grade of RF and optical fiber.
 Observe handling of all cables to prevent damage.
3.3 INSTALLATION PROCEDURES
3.3.1 GOODS INWARDS INSPECTION
ComFlex was factory tested, inspected, packed, and delivered to the carrier with utmost care. Do not
accept shipment from carrier which shows damage or shortage until the carrier’s agent endorses a
statement of the irregularity on the face of the carrier’s receipt. Without documentary evidence, a claim
cannot be processed.
Open and check each package against the packing list. For any shortage, contact Comba Telecom
Systems. Do not remove items from packing materials until installation.
3.3.2 TOOLS
See Appendix A for a full list of tools required for installation and maintenance.
3.3.3 PREPARATION
Optical Fiber: