User's Manual

ENU STATUS : 1-0-0
Copyright - refer to title page
Page 22
INSTALLATION GUIDE FOR RX-7W22, II2
3.3.4 WALL MOUNTING
 Drill four holes on the wall using the position of four holes on the mounting rack as a guide. Fix the
mounting rack to the wall using four masonry bolts (M10x110mm).
 Install the Mounting Rack to the wall.
 Hang the equipment and secure the enclosure to the mounting rack.
Figure 5: PS BDA Wall Mounting
3.3.5 DRIP-LOOP
Comba recommends that every horizontal cable entry to the equipment forms a 'U' before its entry to the
equipment. Water on the cable will drip down at the bottom of the loop and will not accumulate at the equipment
connectors.
Mounting Rack
Masonry bolt
4-M10x110
6-M8x25, Hex socket
with washer bolt
RX-7W22