User's Manual

MCPA TBS SYSTEM USER MANUAL

0.2 IMPORTANT SAFETY NOTICE

Before the installation, please read this section carefully and follow on all detailed

safety instructions. A safe and successful installation relies on your careful reading and

following.

1. GENERAL SAFETY INSTRUCTIONS

DANGER

Follow on following instruction can avoid severe injury or critical damage to the

equipment:

z Before the installation or system operation, review the hazards which could

occur during mechanical installation, RF and electricity connections.

z The rack or outdoor cabinet is setup at a flat ground or platform.

z Do not force to install equipment onto the rack or cabinet which can’t

support its weight.

z Do not do any operation for TBS system when your hands are wet.

z Do not do cleaning for equipment with wet cloth, liquid cleaner, solvent or

aerosol cleaner.

z In order to avoid electrical shock, do not recover circuit packs or touch DC

terminals without any protection.

z In order to avoid strong radiation, please switch off the RF input from BTS.

Before startup TBS system, RF input cables and RF output feeder lines are

properly connected to Passive Module.

z Check the voltage and current request and do not connect the wrong

voltage power source.

z Check the power cable requirement for right voltage and current.

z Do not do power connection before main breaker is still on.

z Do not expose the equipment to liquid, moisture, or oily or water vapor of

any kind, under any conditions.

z Do not put your hands into the running blade of cooling fans.

WARNING

Follow on following instruction can avoid and eliminate the possibility for

personal severe injury or damage to equipment:

z Read and review the site preparation and assure good ventilation for heat

dissipation.

z Avoid to knock at some hard things and hurt your body, make sure the

move direction and sight is clear when move equipment,

z Have enough support or lift capability when do mechanical installation

which is beyond one person’s ability.

z Check the labels carefully and install the right modules in right system.

z Do not expose the equipment to direct sunlight or a high temperature

place.

z Install blank panel for empty slots.

z Do not put hands or other things into empty slots.

z Do not place other things on the top of equipment.