Instruction manual

Back carry position

Back carry (After neck muscle has developed ~ around 14.9kg)

Preparing the base vest

Extend the base vest

Release the length adjustment snaps on the

lower part of the base vest, pull out the

base vest and secure it back to the snaps

for back carry position.

way 4

• When use in cuddling position, one should put on the base vest to which the cuddle-use cushion has

been attached, and then seat the baby into the carrier.

• The length adjustment snap must be snapped in extended position.

• Newborn baby whose neck muscle has not yet developed should use in cradle position.

Cuddle-use cushion (Head support belt must be set to the back carry position /

as demonstrated)

Base vest (Length adjustment snap in extended position)

Parts required

Snaps for cuddling

(front)

Snaps for back carry

(rear)

Setting the cuddle-use cushion

Fasten the 2 lower buckles (male)

on the cuddle-use cushion to the

centre belt buckle (female) on the

base vest. Secure the snap.

Snap

Cuddle-use cushion

When the baby is growing bigger with its shoulders starting to lean against the head support,

Extend the depth adjustment belt to increase the sitting depth of the cuddle-use cushion. Apply

also the securing tape when the adjustment belt is pulled out completely. (Refer to P.12)

Secure the waist buckle

Pull the waist belt round to the front and

fasten the buckle. Adjust the belt to a suitable

length.

Set the pad on the base vest such that it

fits well to the waist.

Pad

Waist belt

Base vest

Waist buckle

Proper length of the

head support belt

Proper belt length in

back carry position