User Manual

8
www.combisteel.com
WARNING:
Your cooler can have a fluorescent lamp. If the fluorescent lamp doesn’t illuminate
or start blinking, please call technical service to repair it in a short while. Please do
not remain your cooler whit non-working lighting system.
WARNING:
Your cooler can have a LED illumination. If you face any problem with LED
illumination, never try to repair it yourself. Inform an authorized service.
Mounting the shelves:
There are 5 shelves provided with the models 7464.0085, 7464.0090, 7464.0095, D148, SC505TF; 3 with S240SC;
2 with S149 and S88SC; and 1 with S56SC. First insert the uppermost shelf in the uppermost hooks in the body.
Insert the others correspondingly with the same method. Chilling process in the body takes place through the
internal air circulation. Therefore do not place the shelves very close to one another.
For models SC505HP, SC505 STD, SC600, S650:
There are 5 shelves and 20 shelf supports shipped inside the cooler. Carry out the following to mount the shelves.
- Pilasters are numbered to provide height adjustment between the shelves in line with the product
requirements. Place the shelf supports into corresponding notches on the pilasters. For an easy
placement, use a pair of pincers to grip the support ends.
- Lay down the four shelves on the cooler floor. (Make sure that the right-angled (90°) side is at the rear).
- Hold the uppermost shelf; tilt one side and place on the hooks on the corresponding supports.
- Do the same for the remaining shelves and mount them all.
Removing the pallet and inserting the feet
Your single door cooler has been delivered on a wooden pallet, screwed to the body at four corners. Please carry
out the following to detach the pallet before the body is set in its final operation location:
- Cut the 4 cable ties fixing to pallet to the cooler chassis by the means of a hand tool (except to S56SC
and S88SC).
- Use a wrench to loosen and remove the head screws on the front and rear corners that fix the pallet to
the base (only for S56SC and S88SC).
- Carefully detach the pallet from the body base. Please find the feet of the cooler provided interior. Insert
them in the screwed sockets at the bottom of the cooler and make the height adjustment.