User Manual

9
www.combisteel.com
Defrosting:
Your cooler is devised with an automatic defrosting system regulated by the thermostat. Defrost water
accumulates in the channel underneath the evaporator; it is then carried to the drip tray by the help of a hose
where it evaporates.
You can speed up defrosting by means of placing a bowl of hot water underneath the cooler (make sure that it
is not boiled). After defrosting, clean the body and make sure to wipe it out leaving no moist inside. Plug the
body again and reload the cooler after one hour.
6. CLEANING, MAINTENANCE AND TRANSPORTATION
To ensure higher efficiency, your cooler must be regularly cleaned. Never use any cleaning agent that contains
alcohol, scouring powder or powerful solvents. Always remove the plug from the mains socket before cleaning
the cooler. Add two teaspoons of baking soda (bicarbonate of soda) in 1 liter water and use the mixture to clean
the cooler. Clean the outer part with a wet cloth and then wipe it out.
Attention: never use any hot water, electrical heater, sharp tools or similar things as they may ham the cooler.
Holidays/stop using for a while:
Do not unplug your cooler if you are going on a holiday or stop using it for a short time. If you are going on a
holiday or stop using the body for a long time, unplug the cooler and empty it. After defrosting, clean the cooler
and wipe it out with a cloth. Leave the door open to prevent odour in the cooler.
Transporting your cooler:
Before relocating the body, unplug it from the mains socket, defrost it, wipe the interior walls and floor with a
damp cloth, place the plastic blockings between the glass door and the body and carry it in the normal position
as it is used.
Attention: expansion gas (C-Pentane) is used in the insulation system of the cooler. When you dispose the body,
it requires observing the applicable laws and rules of the country in which it is used.
Cleaning / maintaining of your cooler’s condenser must be done at least two times in a year by authorized
service.
7. TROUBLESHOOTING
If the cooler does not function:
 Check if the cooler is properly plugged in the mains socket.
 Check if there is electric current to the mains socket.
 Check if the fuse has blown out.
 Check if there is power failure.
If the cooler operates more frequently than desired:’
 Check if the door is opened very frequently or left open for a long time.
 Check if the thermostat is set to chill more than desired.
 Check if the compressor compartment is properly ventilated or compressor compartment needs
cleaning.
If the cooler does not cool enough:
 Check the temperature setting.
 Check if the door is opened very frequently or left open for a long time.
 Check if the internal air circulation is interrupted by overloading.
 Cleaning/maintaining of condenser might not be done (please see Section 6).