Operating instructions

Operation Manual – Art. 80153 (Version 1.1.6)

2.5 Remote Control (optional)

3. GETTING STARTED

Install a hard disk drive into your DVR.

Connect cameras (up to 4) to DVR.

Connect other peripheral devices (mouse, USB Drive, external motion sensors or alarm) if necessary. PS/2

mouse must be connected to DVR before startup system.

Plug the power cord into the plug on the wall.

Start TV Monitoring and Recording.

 Make sure that a hard disk drive and camera(s) are properly installed.

 The hard disk (IDE) jumper setting must be set to “MASTER “!.

 If the power is turned off while recording (i.e. a power failure), the DVR will enter “Power Recovery”

mode at start up, detect that it has been shut down and then reinitiate the recording process.

1. CH1 ↑

Select or enlarge CH1 or Move dome up

2. CH2 ↓

Select or enlarge CH2 or Move dome down

3. CH3 ←

Select or enlarge CH3 or Move dome left

4. CH4 →

Select or enlarge CH4 or Move dome right

5.QUAD

Quad View

6. ◄◄ Z-

Rewind or Zoom-

7. ► F+

Play record list or Focus+

8. ►► Z+

Forward or Zoom+ or Channel auto sequence switch

●

Manual recording or Stop manual recording or Reduce

value or Level scan

10. ▌▌ F-

Pause or Focus-

11. ■

Stop playing or Stop dome running

12. PTZ

PTZ Switch

13.Menu/ESC

Enter or exit setup menu

14.Select/Enter

Modify item or Increase value

15.UP

Move up the cursor

16.DOWN

Move down the cursor