Manual

5
a
b
c
d
f
h
i
g
e
1. Open the software ViP Manager version 2.3.0 or later (downloadable from the website www.comelitgroup.com).
2. From Options [a] / Local connections [b] untick the DHCP enable box and assign an IP address to your PC [c] (in the
example: 192.168.1.2)* that belongs to the same network as the IP address of interface A (default=192.168.1.200) and confirm
[d].
* the last value must be within the range of 2 to 253 excluding: 200 (assigned to the gateway Art. 1456B) and the values
already assigned to other devices connected to the network.
ASSIGN TO INTERFACE “A” A NEW Static IP address
The following procedure describes how to assign network settings to the device1456B that are compatible with those of the devices
connected to interface A.
» all the devices connected to the system will be displayed in the device list.
2. Launch the system scan by pressing Scan System [e].
3. Select device 1456 B [f], select Addressing/ViP address [g], assign an unequivocal ViP address to the device [h] and press Write
page [i] to save the current settings.
In the case of a system with 2 1456B devices, it will be necessary to assign to interface A of one of the two devices
a new Static IP address (as described in "case 2"), as each device must have a unequivocal IP address.
OBSERVE THE FOLLOWING PROCEDURE IN CASE 2
Assign to the PC an
IP address that is
compatible with the
network of the 1456B
(e.g.: 192.168.1.2) so that
the two devices are able
to communicate
CASE 1CASE 2
< BACK