User guide

8
LEFT (0~474)
0=left
RIGHT (0~474)
474=right
COLOUR (1~8)
Sets the colours of the privacy zones.
TRANSP (0.00/0.50/0.75/1.00)
Sets the transparency of the privacy zone area if colour is selected.
MOSAIC (ON/OFF)
Sets the mosaic function as the privacy to ON or OFF.
(Note: when ON, transparency needs to be set at 0.00 and privacy zones
can only be 1 colour OR mosaic and not mixed)
DAY/NIGHT
AUTO
BURST (ON/OFF)
Allows the colour burst signal in monochrome to be removed if required.
DELAY CNT (0-255 secs)
Sets the hysteresis time before switching between colour/mono
& mono/colour, to reduce the ‘hunting’ effect.
DAY->NIGHT (0-255)
Sets the threshold for switching from day to night operation.
NIGHT->DAY (0-255)
Sets the threshold for switching from night to day operation.
COLOUR (colour only operation)
B/W (monochrome only operation)
BURST (ON/OFF)
Allows the colour burst signal in monochrome to be removed if required.
NR (2D-DNR)
This is used to remove noise from the image in low light conditions when
AGC is applied.
NR MODE (OFF, Y, C, Y/C)
Sets the 2D NR filter mode.
Y LEVEL (0-15)
Sets the Y filter (Luminance) strength.
C LEVEL (0-15)
Sets the C filter (Chrominance) strength.