Instruction Manual

Control Indicator Guide
2
There are three control modules of the Comeup automotive winches. All are similar in setup, but have
differing responses in regards to their control type.
Determine which model you have and refer to the charts for you particular models signalling of its
condition through LED’s and buzzer
.
Wired Remote Control Module
Available Winches Seal 9.5i/9.5si; DV-9i/9si
LEDs on the bridge control box
LEDs on the remote control
LED Locations
Left LED Right LED LEDs
Plug in Connector Green Green Green
Cable In/Out Operation Green Green Green
Motor Overheating Warning Red Red Red
ffo snrut DEL rotcennoC tuO gulP
Available Winches
Seal 9.5 / 9.5s/12.5/12.5s
DV-18/15/12/9/9s
DV-12 light/12s light
Wireless Control Module on the dual control modules
They can be controlled by the wireless control module or the wired remote control module, but only
one control way can activate the winch at the same time.
isr5.9 laeS hcniW elbaliavA
LEDs and buzzer on the bridge control box
LED & Buzzer
Left LED Right LED Buzzer
LED on the
wireless
transmitter
Press Transmitter for 5 seconds Green X X Green
Cable In/Out Operation Green Blue X Red
deR eulB tuo/nI elbaC
Motor
Overheating
Warning
No Working
Red
X
2 short Beeps
every 5 seconds
Green
Low Voltage on Transmitter
Warning
X X X Blinking Green
Poor Signal Warning X Blinking Blue X Blinking Red
sehcniW elbaliavA
Seal 9.5rs / 12.5rs
(Buzzer in the control box)