User guide

Control Indicator Guide
4
X Wired Remote Control Module on the dual control modules
Available Winch Seal 9.5rsi
LEDs and buzzer on the bridge control box
LED & Buzzer
Left LED Right LED
Buzzer
LEDs on the
remote control
Plug in Connector Green X X Green
Cable In/Out Operation Green X X Green
Motor Overheating Warning Red X
2 short Beeps
every 5 seconds
Red
Plug out Connector
LED turns off
Available Winches
Seal 9.5rs / 12.5rs
(Buzzer in the control box)
Remarks:
1. Green LED illuminates when the winch is operating under normal working conditions.
2. Red LED illuminates when the winch is operating when overheating of the motor. Stop operation
and allow winch to cool (Green LED)
3. The LEDs illuminate or the beeping buzzer alarms when the motor is overheating.
X
Wireless Receiver & Transmitter Operation
1. Replacing Battery
If the LED Indicator blinks Green, the battery is low and should be replaced.
a. Remove the three screws from the wireless transmitter.
b. Separate the top section and remove the old battery and dispose it.
c. Insert new lithium battery and join the top section with the bottom section.
d. Make sure to fasten the three screws.
2. First Installation/Re-programming the Receiver
The transmitter is programmed from the factory and under normal circumstances it won’t be
necessary to program it. Use the following procedures for any programming of the receiver.
a. Attach the red(+) and black(-) leads to battery set on the vehicle, then the buzzer beeps for 5
minutes and the Right LED on the bridge control box blinks Blue.
Lithium Battery: CR2032 (3V)
0678