User guide

Mounting Guide
8
X Clutch Repositioning
Change the position of the Free-Spool T-handle according to the following steps.
1. Loosen and release the bolts on the brake rear cover for separating the brake rear cover away.
2. Loosen and release the bolts on the gearbox away for separating the gear box away (Only for
Seal series winches).
3. Rotate the gearbox by a proper angle increments mentioned on the below chart to the required
position.
4. Re-assembly the gearbox and rear brake cover.
X Mounting Configurations
The payout direction for wire rope/synthetic rope or the correct methods for mounting the winch
vary according to different winch model. Do wind the rope from the bottom of the drum for foot
down mounting winch. Do wind the rope from the top or bottom of the drum towards the direction of
the mounting base plate for foot forward mounting winch. At any condition, do not position the load
direction away from the mounting base plate.
Foot Down Mounting Position Foot Forward Mounting Position
Mounting Position Repositioning
Winch Model
Foot Down
Foot Forward
Clutch Angle Motor Angle
Seal 9.5/9.5s/9.5rs
V V
90∘ 90∘
Seal 9.5i/9.5si/9.5rsi
V V
90∘ 90∘
Seal 12.5/12.5s/12.5rs
V
90∘ 90∘
DV-18
V
36∘ 90∘
DV-12/15
V V
36∘ 90∘
DV-12 light/12s light
V
40∘ 90∘
DV-9/9s/9i/9si
V V
40∘ 90∘
DV-6000S
V V
90∘