Install Instructions

Heat Controller VFH InverterFlex

- Indoor Ductless Mini-Split

Features and functions of wireless remote control

SLEEP

SLEEP button

Operation of wireless remote control

• When the initial set temperature is between 82°F-85°F

(28°C-29°C), the temperature will increase 1-2 degrees

every hour until a 1-2 degree increase is achieved and

that will be maintained for (7) hours. After (7) hours,

the temperature will decrease another 1-2 degrees and

continue to operate under this condition.

• When the initial set temperature is 86°F (30°C), after 7

hours the temperature will decrease 1-2 degrees and

continue to run under this condition.



• When the initial set temperature is set to 61°F (16°C),

the unit will maintain this temperature.

• When the initial set temperature is between 62°F-68°F

(17°C-20°C), the temperature will decrease 1-2 degrees

every hour until a 1-2 degree decrease is maintained.

• When the initial set temperature is between 69°F-81°F

(21°C-27°C), the temperature decreases 1-2 degrees

every hour, then this temperature is maintained.

• When the initial set temperature is between 82°F-86°F

(28°C-30°C), the temperature decrease 1-2 degrees

every hour until a 5-6 degree decrease has been

achieved. Then the unit will continue to operation under

this condition



Allows customization of the Sleep mode conditions by

setting the temperature and hours it will be maintained

up to 8 hours. To create the individualized program under

the Sleep 3 mode, hold the turbo button until the remote

control displays “1 hour” and the set temperature will

display and blink “88”. Adjust the set temperature by

pressing the (+) or (-) buttons for the rst hour of sleep

mode. Press the “Turbo” button to conrm. The remote

will advance to the next hour and display “2 hours” and

allow you to set the temperature again. After the set

temp is set, press the turbo button to conrm. Repeat

this process for the 8 hours of Sleep mode, setting

the temperature for each hour. After programming is

complete, the remote will resume it’s normal display.