User guide

10° BACK
WARNING: This product requires the use of the anti-tip bars on the wheelchair.
Toll Free 800.564.9248
www.comfortcompany.com
509 South 22nd Ave Bozeman, MT 59718
IS-10BACK
REV0413
A CB
Remove existing back from wheelchair (A).
Slide loops at top of back around wheel-
chair canes.
1
2
Choose one of two grommet holes that
works best for back placement. If existing
holes in wheelchair canes do not work,
drill out with 5/32” drill bit for standard
sling screws (B).
3
4
5
Attach long strap to wheelchair tubing
using screws from sling back.
Pull center strap as tight as possible.
Tighten rear strap. Tighten front strap
until from of seat is at desired height. This
locks the unit in place (C).
REARVIEW