Owner manual

LOWRIDER
Remove existing sling seat from wheelchair. To determine which of the three hole locations (a) to
install the L-bracket, hold dropseat over wheelchair so that L-bracket clears wheelchair cross
members and hardware.
Loosely secure L-bracket to Drop Seat base (B) using hardware in kit bag #1.
Toll Free 800.564.9248
www.comfortcompany.com
509 South 22nd Ave Bozeman, MT 59718
1
2
Determine the amount of seat drop required. Using the short screw in kit bag #2, mount J-hook
(C) to L-brackets.
3
Place Drop Seat in wheelchair. Adjust L-bracket to width of chair (D) (Seen in Diagram 1). Make
final adjustment of seat height and angle. Tighten all screws. Assemble securing clips in kit bag
#3. Mount secure clip on the outside of J-hook as shown above (E).
4
IS-LOWRIDER
REV0413
Warning: Securing clips must be installed to secure back to wheelchair canes.
(E)
Side View
(A)
(D)
L Bracket
Bottom View
1
(B)
J Hook
Washer
Lock Washer
L Bracket
End View
2
Finger tighten longer screw, washer and nut
(C)
Side View (close-up)
3
4
®