Installation Guide

~ 6 ~
INSTRUCTIONS FOR POWER
WARNING: Before servicing this heater be sure to unplug heater from wall outlet. Do
not only turn off heater from the main “ON/OFF” switch, be sure to unplug this heater.
Note: The power cord has a polarized plug (with one blade wider than the other) that will only fit in a
polarized outlet one way. If it does not insert easily try reversing the plug. If it still does not fit contact your
electrician to replace your outlet. DO NOT defeat the safety purpose of the polarized plug.
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60Hz circuit
with a properly grounded outlet is
required. The heater should be on
a dedicated circuit. Other
appliances on the same circuit
may cause the circuit breaker to
trip or the fuse to blow when the
heater is in operation. The unit
comes standard with a 6'
(1828mm) long three wire cord
exiting from the rear of the
fireplace.
WARNING: Electrical
outlet wiring must comply with
local building codes and all
other applicable regulations to
reduce the risk of fire, electrical
shock and injury.
WARNING: Do not use this
fireplace if any part of it has been
under water. Immediately call a
qualified service technician to
inspect the fireplace and replace
any part of the electrical system if
necessary.